There are certain factors that you have to consider when replacing the water inside your aquarium, and temperature is one of them. It is unfortunate to know that there are often times when an aquarist makes the mistake of pouring in liquid that is too cold for the fish to bear, causing them to become stressed, or get sick. To make sure that this will never happen to your friends, you should always be prepared with the Hydor ETH 201 In-Line Heater from Pet Store
. This can be used for both fresh and marine tanks.
This heater is meant to be installed outside the aquarium
, and it has access to your water by a set of tubes, which have a thickness of 5/8 of an inch. The device operates on 200 watts of energy, guaranteeing you that it has enough power to change your aquariums temperature within seconds. It is also self-aware, automatically shutting down when the liquid becomes too hot for your fish. Still, it is important that you monitor the gadgets progress to ensure that your friends are comfortable.
The Hydor ETH 201 In-Line Heater will not take too much space since it will be set up outside the tank. It is quite the effective accessory, which will ensure that your fish are comfortable and warm inside their new home.ETH 201 In-Line Heater UL Listed 200 Watt for 16mm & 5/8" Hose
External thermal heater which includes the PTC system. Suitable for all external canister filters
The Hydor ETH in-line external heater is designed for vertical use in most aquarium applications involving water hose of the specified diameter. The ETH must be used in a vertical manner for correct operation. The most common application is for use with canister filters however the ETH is easily adapted for use in almost any situation where heated aquarium water is required, such as with wet/dry sump pumps. The ETH is easily installed by cutting the tubing and connecting the two parts of the tube to each side of the ETH. For reduced maintenance, it is recommended that the ETH be installed within the filter`s output assembly. As most canister filters are not designed to bear weight, it is recommended that the ETH be properly supported by the use of the attached loop to avoid stress on the output assembly. The ETH is completely safe and UL Listed. There is no danger of damage if the ETH is left running dry for short periods as the ETH will switch itself off in that event. The ETH heats with high efficiency by means of an internal heat pump system that avoids temperature variations. For use in freshwater and marine aquariums. Fits most canister filters such as the Hydor Prime, the Rena Filstar, Eheim canisters, and the Fluval canisters with the use of a short section of tubing to complete the connection. Use of the ETH cleaning brush is recommended.
- Completely safe. No danger of damage if the equipment is left running without water for a short period of time.
- Patented heating element made with the exclusive PTC system. The traditional metal resistor coils have been replaced by a special polymer sheet, silk-screened with heating ink.
- Setting of temperature controlled by an electronic circuit with indicator light.
- Connectors suitable for any flexible pipe of all external filters.
- Two year manufacturer`s warranty.