Are you tired of your aquarium plumbing constantly breaking down? Or are you in the process of improving the flow of the plumbing connection of your aquarium? Then you should always remember to get hold of only the top quality parts for your aquarium plumbing connections! With the JG white union tee from Pet Store
you can be rest assured that all the connections in your aquarium are as they should be, tightly fitted and free from leaks.This t-shaped tube fitting definitely does what it was built for. With this JG union tee, you will not have any problem configuring the flow of your aquarium plumbing. Like most t-shaped tube fitting, it is also very easy to install. Inserting the tubes into the fitting is not too difficult with this union tee. This important aquarium part is also long-lasting and can be reused as often as needed with the proper installation and use of suitable auxiliary parts.
Always make sure that your aquarium plumbing system is depressurized before you remove the tube fitting. With the JG union tee, you can be sure of the quality of the plumbing connections in your aquarium and be at peace that your aquatic pets
are safe and secure.
John Guest Part# : CI0208W
Tube O.D.: 1/4"
How to make a connection
- Cut tube square
It is essential that the outside diameter be free of score marks and that burrs and sharp edges be removed before inserting into fitting. For soft or thin walled plastic tubing we recommend the use of a tube insert.
- Insert tube
Fitting grips before it seals. Ensure tube is pushed in to the tube stop.
- Push up to tube stop
Push the tube into the fitting, to the tube stop. The collet (gripper) has stainless steel teeth which hold the tube firmly in position while the "O" ring provides a permanent leak proof seal.
- Pull to check secure
Pull on the tube to check it is secure. It is good practice to test the system prior to leaving site and/or before use.
Push in Collet and remove tube
To disconnect, ensure the system is depressurized before removing fitting. Push in collet squarely against face of fitting. With the Collet held in this position, the tube can be removed. The fitting can then be re-used.