Some valves are made with poor quality that they start leaking on your first day of use, but you never have to worry about this with the JG Union Ball Valve from
Pet Store. This product guarantees quality for your money. Most valves in the market tend to be extremely difficult to turn after quite some time but this product’s sturdy, easy-to-adjust feature sets it apart. This high-performance valve can absolutely hold pressure even after multiple disconnections. This product connects into ¼ inch tubing. The white-colored, lightweight union ball valve that is 0.5 ounces assures you of excellent functionality.
This product is super easy to connect and remove. To make a connection simply cut the tube square, then insert the tube. Afterwards push up to tube stop and then pull on the tube to check a secure fit. See, it’s as easy as one, two, three!
John Guest (JG) has been in the industry since 1961. With the long-time experience in innovative and quality products together with the birth of its Super Speedfit technology, there is no room left to doubt about the superiority of this product.
Say goodbye to leaks and hello to hassle-free connection with the JG Union Ball Valve. Buy one today and see the difference!
Color: White
John Guest Part# : PPSV040808W
Tube O.D.: 1/4"
Tube O.D.: 1/4"
Specifications
Color: White
John Guest Part# : PPSV040808W
Tube O.D.: 1/4"
Tube O.D.: 1/4"
How to make a connection:
- Cut tube square.
Cut the tube square. It is essential that the outside diameter be free of score marks and that burrs and sharp edges be removed before inserting into fitting. For soft or thin walled plastic tubing we recommend the use of a tube insert. - Insert tube.
Fitting grips before it seals. Ensure tube is pushed in to the tube stop. - Push up to tube stop.
Push the tube into the fitting, to the tube stop. The collet (gripper) has stainless steel teeth which hold the tube firmly in position while the "O" ring provides a permanent leak proof seal. - Pull to check secure.
Pull on the tube to check it is secure. It is good practice to test the system prior to leaving site and/or before use.
Disconnecting:
Push in Collet and remove tube.
To disconnect, ensure the system is depressurized before removing fitting. Push in collet squarely against face of fitting. With the Collet held in this position, the tube can be removed. The fitting can then be re-used.
